GEAR MOTOR MR 977 63

MR97763 ok

 MR97763 2

 

TIPO  RATIO  L
mm		 *R.P.M. no load
min-1 		  *R.P.M. S 1
min-1		 S1 torque
Nm 		 *R.P.M. S2
min-1 		 S2 torque
Nm 		 Max torque
Nm		 I max
24 Vdc 
MR 977 63 1/4 4 189 710 630 1 510 2,2 8 38
MR 977 63 1/6 6 189 480 430 1,5 350 3,4 12 38
MR 977 63 1/16 16 209 180 160 4 130 8,5 30 38
MR 977 63 1/24 24 209 120 105 6 88 12 45 38
MR 977 63 1/36 36 209 80 70 9 60 19 67 38
MR 977 63 1/64 64 229 45 40 13,5 32 30 102 38
MR 977 63 1/96 96 229 30 26 17 22 43 120 30
MR 977 63 1/144 144 229 20 17 26 15 52/6,2A 120 18
MR 977 63 1/216 216 229 13,5 12 25/2,7A 11,5 52/4,6A 120 12

 

Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
977 130 output W 2900 Rpm loadness, 12 or 24 Vdc. Starting corrent 38 A.
 
Driving shaft supported by self lubrificanting bushings. Output shaft supported by two coupled screened bearings. The motor’s surface and reducer’s surface are both plated to avoid corrosion.
Connecting wires 1 x 300 mm.
 
*The rotation speed can change of ±10%.
 
The S1 load test was made using a (3,8 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (7,5 A) corrent in the air with a 50% timing 5`with an increase of temperature
of 80° C max.
The starting corrent is (I max) and must not maintained for more than 2".
 
Max load on the extremity of output shaft: Axial 300 N, Radial 400 N
 
Possibility to apply other motor.