GEAR MOTOR MR 737 35Q

MR73742E

 MR73742Ef

 

TIPO   Rapporto
riduzione		  L
mm		 R.P.M. a vuoto
*min-1 		  R.P.M. S 1
*min-1		 Coppia S1
Nm 		 R.P.M. S2
*min-1 		 Coppia S2
Nm 		  Coppia Max
Nm		 I max
24 Vdc 
MR 737 42 E 1/4 4 104  1200 1020 0,1 850 0,21 0,75 5,5
MR 737 42 E 1/6 6 104 800 680 0,14 570 0,28 1 5,5
MR 737 42 E 1/16 16 119 300 265 0,43 220 0,85 3 5,5
MR 737 42 E 1/24 24 119 200  170 0,57 140 1,14  4 5,5
MR 737 42 E 1/36  36 119 135 115 0,86 95 1,72 6 5,5
MR 737 42 E 1/64  64 135 75 65 1,45 55  2,8 10 5,5
MR 737 42 E 1/96  96 135 50 42 2,3 35 4,6 16 5,5
MR 737 42 E 1/144 144 135 33 28 3,15 23 6,3 22 5,5
MR 737 42 E 1/216 216 135 22 18 4,6 15 9,2 32 5,5

 

Length “L” of the gearmotor as a funtion of reduction and output number of revolution with the standard motor 737 22 output W 5000 Rpm loadness, 12 or 24 Vdc. Starting current 5,5 A.

This data sheet refers to the version 24 VDC.

 

Output shaft is supported by two screened bearings.

The motor’s surface and reducer’s surface are both zinc plated to avoid corrosion.

Max load act on the extremity of output shaft: Axial 100 N, Radial 150 N

 

*The speed rotation can change of ±10%.

S1 is a continuos work with a maximum current of 1A (1,8 A x 12 Vdc).

S2 is an intermittent work (5’ ON 5’ OFF with a maximum current of 1,7 (3 A x 12 Vdc).

 

The starting current  (I max) I Max x 12 Vdc 10A) must not mantained for more than 2”.

 

It is possible to apply an encoder.