GEAR MOTOR MR 752 L 52-60

MR752L63 ok

 MR752L63 2

 

TYPE  RATIO  L
mm		 *R.P.M. no load
min-1 		  *R.P.M. S 1
min-1		 S1 torque
Nm 		 *R.P.M. S2
min-1 		 S2 toque
Nm 		 Max torque
Nm		 I max
24 Vdc 
MR 752 L 52-60 1/4 4 163 760 660 0,5 450 1,3 3 14,5
MR 752 L 52-60 1/6 6 163 500 440 0,7 310 2 5 14,5
MR 752 L 52-60 1/16 16 182 185 165 1,7 115 4,8 12,2 14,5
MR 752 L 52-60 1/24 24 182 120 105 2,5 75 7,2 18,7 14,5
MR 752 L 52-60 1/36 36 182 80 70 4 55 11 28 14,5
MR 752 L 52-60 1/64  64 202 45 36 6 26 17 43 14,5
MR 752 L 52-60 1/96  96 202 30 25 9 18 25 63 14,5
MR 752 L 52-60 1/144 144 202 20 18 12 12 36 95 14,5
MR 752 L 52-60 1/216 216 202 13 11 8 8 54 120 12,5

 

Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
752 L 60 output W 3200 Rpm loadness, 12 or 24 Vdc. Starting corrent 14,5 A. (28A x 12Vdc)
 
Drivingshaft supported by self lubrificating bushings. Output shaft supported by two coupled screened bearings.
The motor’s surface and reducer’s surface are both plated to avoid corrosion.
The motor has an electrical suppressor system for the CE standard.
Connecting wires 0,75 x 250 mm.
 
*The rotation speed can change of ±10%.
 
The S1 load test was made using a (2,4 A) corrent in the air with an increase of temperature of 70° C.
The S2 test was made using a (6 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max.
The starting corrent is (I max) and must not maintained for more than 2".
 
Max load on the extremity of output shaft: Axial 300 N, Radial 400 N
 
It is possible to apply an encoder.
Possibility to apply other motor.