GEAR MOTOR MR 724 22
|
|
 |
| TYPE | RATIO | L mm |
*R.P.M. no load *min-1 |
*R.P.M. S2 *min-1 |
S2 torque Nm |
Max torque Nm |
I max 24 Vdc |
| MR 724 22 1/16 | 16 | 62 | 620 | 280 | 0,11 | 0,2 | 1,6 |
| MR 724 22 1/64 | 64 | 70 | 155 | 70 | 0,44 | 0,8 | 1,6 |
| MR 724 22 1/256 | 256 | 78 | 39 | 17 | 1,2/0,5A | 1,5 | 0,7 |
Length "L" of the gearmotor as a funtion of reduction and output number of revolution with the standard motor
724 5 output W 12000 Rpm loadness, 12 or 24 Vdc. Starting corrent 1,6 A.
724 5 output W 12000 Rpm loadness, 12 or 24 Vdc. Starting corrent 1,6 A.
Output shaft is supported by two coupled screened bearings.
The motor and the reduction gear are both plated for corrosion strength.
The motor and the reduction gear are both plated for corrosion strength.
*The speed rotation can change of ± 10%.
The S2 test was made using a (0,85 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80° C max. The starting corrent is (I max) and cannot be mantained for more than 2".
of 80° C max. The starting corrent is (I max) and cannot be mantained for more than 2".
Max forces which may act on the output shaft: Axial 80 N, Radial 100 N on the extremity of output shaft.