Length “L” of the gearmotor as a function of reduction and output number of revolutions with the
standard motor 742 30 output W, 3700 Rpm loadness, 12 or 24 Vdc. Starting current 5,5 A. The data sheet
refers to the version 24Vdc.

Output shaft is supported by two screened bearings.
The motor’s surface and reducer’s surface are both zinc plated to avoid corrosion.
The motor has an electrical suppressor system for the CE standard.
Connecting 2 wires 0,75 mm2 x L 250 mm.

* Rpm can change of ±10%.

The S1 is a continuos work with a maximum current of 1,2 A (2,2 A x 12 Vdc).
The S2 is an intermittent work 5’ ON 5’ OFF with a maximum current of 1,6 (3 A x 12 Vdc).
The starting current I Max (I max x 12 Vdc 10A) must not maintained for more than 2”.

Max load on the extremity of output shaft: Axial 100 N, Radial 150 N.

It is possible to apply an encoder.

The design of Bernio gearmotors is fully focused on uptime, process safety and repeatable performance. Each component is developed and validated in Italy according to strict industrial standards. As a result, the drive system maintains efficiency and stability, reducing the risk of unplanned downtime.

Main features

• Italian-designed gearmotors focused on service continuity.
• Gearmotors tested on extended duty cycles.
• Components sized to withstand torque peaks and heavy loads.
• Gear units with geometries engineered to minimize backlash and vibration.
• Selection of high-strength mechanical materials.