Gearmotor with helical gears in the input stage to avoid and reduce noise.
Length "L" of the gearmotor as a function of reduction and output number of revolutions with the
standard motor 752 L60 output W, 3200 Rpm loadness, 12 or 24 Vdc. Starting current 14,5 A. The data
sheet refers to the version 24Vdc.

Output shaft is supported by two coupled screened bearings.
The motor’s surface and reducer’s surface are both zinc plated to avoid corrosion.
The motor has an electrical suppressor system for the CE standard.
Connecting 2 wire x 0,75 mm2 L 250 mm.

* Rpm can change of ±10%.

The S1 load test was made using a 2,5 A current in the air with an increase of temperature of 70° C.
The S2 test was made using a 6 A current in the air with a 50% timing 5' with an increase of temperature
of 80° C max.
The starting current (I max) must not maintained for more than 2".

Max load on the extremity of output shaft: Axial 300 N, Radial 400 N

It is possible to apply an encoder.

The Bernio gearmotor range combines mechanical robustness with precise motion control. The gearbox structure is conceived to withstand load variations, torque peaks and continuous working conditions. As a result, the drive system maintains efficiency and stability, reducing the risk of unplanned downtime.

Main features:

• Torque available already at low speed ranges.
• Gear units conceived to minimize unplanned downtime.
• Configurations customizable according to the application.
• High efficiency in power transmission.
• Dedicated technical support for gearmotor selection.