Length "L" of the gearmotor as a function of reduction and output number of revolutions with the
standard motor 756 L90 output W, 3200 Rpm loadness, 12 or 24 Vdc. Starting current 22 A (44 A x 12
Vdc). The data sheet refers to the version 24Vdc.

Output shaft supported by two coupled screened bearings.
The motor's surface and reducer's surface are both zinc plated to avoid corrosion.
The motor has an electrical suppressor system for the CE standard.
Connecting 2 wires x 1 mm2 L 250 mm.

* Rpm can change of ±10%.

The S1 load test was made using a 3 A current in the air with an increase of temperature of 70° C.
The S2 test was made using a 7 A current in the air with a 50% timing 5' with an increase of temperature
of 80° C max.
The starting current (I max) must not maintained for more than 2".

Max forces which may act on the output shaft: Axial 300 N, Radial 400 N on the extremity of output
shaft.

It is possible to apply an encoder.
Possibility to apply other motors.