GEAR MOTOR MVSF 752 26
TYPE | RATIO |
R.P.M. no load |
R.P.M. S 1 *min-1 |
S1 torque Nm |
R.P.M. S2 *min-1 |
S2 torque Nm |
Max torque Nm |
I max 24 Vdc |
MVSF 752 26 1/10 | 10,5 | 215 | 155 | 1 | 120 | 1,5 | 3,5 | 6 |
MVSF 752 26 1/15 | 15,5 | 140 | 100 | 1,5 | 80 | 2,4 | 6 | 6 |
MVSF 752 26 1/20 | 21 | 105 | 75 | 1,8 | 60 | 2,8 | 6,5 | 6 |
MVSF 752 26 1/30 | 31 | 70 | 50 | 2,2 | 40 | 3,4 | 8 | 6 |
MVSF 752 26 1/40 | 39 | 55 | 40 | 2,8 | 30 | 4,5 | 10 | 6 |
Worm geared motor with worm screw and standard motor Ø 52 12 or 24 Vdc 2000 RPM loadness 45W. Starting corrent 6 A. (11A x 12Vdc)
Driving shaft mounted with on a bearing and bushing. Output shaft supported by two bearing with oil seal guard on output side.
Connecting wires 0,75 x 200 mm.
Connecting wires 0,75 x 200 mm.
*The rotation speed can change of ±10%.
The S1 load test was made using a (1,8 A) current in the air with an incease of temperature of 70°.
The S2 test was made using (2,9 A) corrent in the air with a 50% timing 5’ with an increase of temperature of 80° max.
The starting corrent is (I max) and must not maintained for more than 2".
The S2 test was made using (2,9 A) corrent in the air with a 50% timing 5’ with an increase of temperature of 80° max.
The starting corrent is (I max) and must not maintained for more than 2".
Max load on the extremity of output shaft: Axial 250 N, Radial 400 N.
It is possible to apply an encoder.