GEAR MOTOR MVSF 742 26
|
|
 |
| TYPE | RATIO | R.P.M. a vuoto *min-1 |
R.P.M. S 1 *min-1 |
S1 torque Nm |
R.P.M. S2 *min-1 |
S2 torque Nm |
Max torque Nm |
I max 24 Vdc |
| MVSF 742 26 1/10 | 10,5 | 340 | 265 | 0,5 | 190 | 1 | 2,3 | 6 |
| MVSF 742 26 1/15 | 15,5 | 220 | 180 | 0,8 | 120 | 1,9 | 4 | 6 |
| MVSF 742 26 1/20 | 21 | 165 | 130 | 1 | 90 | 2 | 4,5 | 6 |
| MVSF 742 26 1/30 | 31 | 110 | 90 | 1,1 | 65 | 2,5 | 5,5 | 6 |
| MVSF 742 26 1/40 | 39 | 90 | 72 | 1,3 | 50 | 2,9 | 6,5 | 6 |
| MVSF 742 26 1/50 | 50 | 70 | 55 | 11,5 | 40 | 2,2 | 5 | 6 |
| MVSF 742 26 1/70 | 69 | 50 | 40 | 1,3 | 27 | 3 | 6,5 | 6 |
Worm geared moto and standard motor Ø 42 30 output W 12 or 24 Vdc 3700 RPM loadness, with electric noise suppressor. Starting corrent 6 A. (11A x 12 Vdc)
Driving shaft mounted on a bearing and bushing. Output shaft supported by two bearings with oil seal on the output side.
Connecting wires 0,75 x 250 mm.
* The rotation speed can change of ± 10%.
Connecting wires 0,75 x 250 mm.
* The rotation speed can change of ± 10%.
The S1 load test was made using a (1,6 A) current in the air with an increase of temperature of 70 C°.
The S2 test was made using a (3 A) corrent in the air with a 50% timing 5' with an increase of temperature of 80 C° max.
The starting corrent is (I max) and must not maintained for more than 2".
The S2 test was made using a (3 A) corrent in the air with a 50% timing 5' with an increase of temperature of 80 C° max.
The starting corrent is (I max) and must not maintained for more than 2".
Max load on the extremity of output shaft: Axial 250 N, Radial 400 N.
It is possible to apply encoder.