GEAR MOTOR MVR 737 30 Q 26
|
|
 |
| TYPE | RATIO |
L mm |
R.P.M. no load *min-1 |
R.P.M. S 1 *min-1 |
S1 torque Nm |
R.P.M. S2 *min-1 |
S2 torque |
Max Torque Nm |
I max 24 Vdc |
| MVR 737 30 Q 26 | 160 | 156 | 32 | 27 | 1,8 | 23 | 3,7 | 13 | 5,4 |
| MVR 737 30 Q 26 | 320 | 156 | 14 | 12 | 2,5 | 10 | 7 | 25 | 5,4 |
| MVR 737 30 Q 26 | 640 | 165 | 8,5 | 7,5 | 6,8 | 6 | 14 | 32 | 3,5 |
| MVR 737 30 Q 2 | 1280 | 165 | 3,5 | 3 | 8/0,75 A |
2,8 | 16/1,2 A |
32 | 2,1 |
| MVR 737 30 Q 26 | 1920 | 165 | 2,8 | 2,4 | 9/0,9 A | 2,2 | 18/1,5 A |
32 | 2,5 |
| MVR 737 30 Q 26 | 2560 | 174 | 2 | 1,8 | 9/o,5 A | 1,6 | 18/0,75 A | 32 | 1,1 |
Worm geared motor and standard motor Ø 37x34 12 or 24 Vdc 5000 RPM output W, with noise suppressor.
Starting corrent 5,4 A.(10A x 12Vdc)
Driving shaft mounted on two bearing and bushing. Output shaft supported by two bearings.
Designed and developed to give low RPM and a small size.
Designed and developed to give low RPM and a small size.
*The rotation speed can change of ±10%.
The S1 load test was made using a (1 A) current in the air with an increase of temperature of 70 C°
The S2 test was made using a (1,7 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80 C° max.
The starting corrent is (I max) and must not maintained for more than 2".
The S2 test was made using a (1,7 A) corrent in the air with a 50% timing 5' with an increase of temperature
of 80 C° max.
The starting corrent is (I max) and must not maintained for more than 2".
Max load on the extremity of output shaft: Axial 250 N, Radial 400 N.
It is possible to apply an encoder.