GEAR MOTOR MVR 752 26 63
|
|
 |
| TYPE |
RATIO |
L mm |
R.P.M. no load |
R.P.M. S 1 *min-1 |
S1 torque |
I S 1 24 Vdc |
R.P.M. S2 *min-1 |
S2 torque Nm |
I S 2 24 Vdc |
Max torque |
I max 24 Vdc |
| MVR 752 26 63 1/120 | 120 | 56 | 15 | 13 | 6,5 | 1,1 | 11,5 | 11 | 2 | 24 | 4 |
| MVR 752 26 63 1/240 | 240 | 76 | 8 | 6,5 | 15 | 1,5 | 5,5 | 28 | 2,5 | 70 | 6 |
| MVR 752 26 63 1/360 | 360 | 76 | 5,5 | 4,5 | 18 | 1,2 | 4 | 40 | 2,5 | 100 | 6 |
| MVR 752 26 63 1/480 | 480 | 76 | 4 | 3,2 | 25 | 1,5 | 2,6 | 45 | 2,3 | 100 | 5 |
| MVR 752 26 63 1/720 | 720 | 76 | 2,7 | 2,3 | 29 | 1,2 | 2 | 56 | 2 | 100 | 3,2 |
Worm geared motor and standard motor Ø 52 12 or 24 Vdc 2000 RPM output 40W, with noise suppressor.
Starting corrent 6 A. (11A x 12Vdc)
Starting corrent 6 A. (11A x 12Vdc)
Driving shaft mounted on two bearing Output shaft supported by two bearings.
Designed and developed to give low RPM and a small size.
Designed and developed to give low RPM and a small size.
*The rotation speed can change of ±10%.
The S1 load test was made using a corrent in the air with an increase of temperature of 70 C°.
The S2 load test was made using a corrent in the air with a 50% timing 5’ with an increase of temperature
of 80 C° max.
The S2 load test was made using a corrent in the air with a 50% timing 5’ with an increase of temperature
of 80 C° max.
The starting corrent is (I max) must not maintained for more than 2".
Max load on the extremity of output shaft: Axial 300 N, Radial 400 N.
It is possible to apply an encoder.